Cutting System Maintenance - Flymo Hover Vac Operating Instructions Manual

Hide thumbs Also See for Hover Vac:

Original instructions manual (10 pages)

Important information manual (12 pages)

Table Of Contents

Table of Contents

•

For optimum performance your product is designed

to be used with the grassbox fitted.

Grassbox full Indicator (P) (Hover Vac only)

•

IMPORTANT

The machine must be switched on for the grassbox

full indicator to operate.

1. When the ball reaches the top of the indicator win-

dow, it is time to empty the grassbox. See figure P .

2. When the ball is NOT visible in the indicator win-

dow, grass is being collected. See figure N.

Emptying the Grassbox (Q)

•

Stop the product and wait until the cutting head has

stopped rotating before emptying the grassbox.

1. Remove the grassbox lid.

2. Lift the grassbox off the product and empty.

3. Replace grassbox and lid carefully.

•

Failure to fit the grassbox and lid correctly will cause

poor collection of grass clippings.

• Always handle the plastic cutters with care - sharp

edges could cause injury. USE GLOVES.

Checking your Cutting System (R)

• The cutting system must be kept in good condition

and inspected before and after use.

• Disconnect from the mains electricity supply and wait

until the cutting head has stopped rotating. Turn your

product upside down.

1. Visually check cutting head for wear. Replace if damaged.

2. Visually check plastic cutters for wear and replace

when necessary.

3. Plastic cutters should be straight. Replace if bent or

twisted.

Replacing Plastic cutters (S)

• Use only genuine Flymo replacement plastic cutters

specified for this product. These are available from

all Husqvarna UK Ltd. Service Centres and major re-

tail outlets.

• Plastic cutters must be replaced in pairs to retain balance.

• Two plastic cutters of the same type should be fitted.

• Never fit a metal bar blade to this product.

To Replace Plastic Cutters

• Disconnect from the mains electricity supply and wait

until the cutting head has stopped rotating. Turn your

product upside down.

1. Push plastic cutter towards centre of cutting disc. Lift

plastic cutter away from cutting head. (T)

2. If the plastic cutter is broken during use - lever cutter

out of the slot, and dispose of carefully.

3. Fit new plastic cutters into the slots at each side of

the cutting head and pull into place. (V)

• IMPORTANT ENSURE PLASTIC CUTTERS ARE

CORRECTLY LOCATED.

Grassbox