Advertisement
INSTALLATION
Please note that all electrical installations should be carried out by a fully qualified electrician in conformance with
the National Electrical Code.
Cut a 20-7/8" x 13-1/2" x 3-1/2" deep recess in the wall board to accommodate the In-Wall Box. The recess in the
wall should be open below the In-Wall Box to allow cables to enter the bottom of the unit. The wall should be of
suitable strength to support the weight of the Bath/Spa TV (32.5 lbs). Vertically mounted 2" x 4" wall studs may
be used to provide extra support to the wall board.
CABLING AND ELECTRICAL INSTALLATION
Please note, all electrical installation should be carried out by a fully qualified electrician in conformance with the
National Electrical Code.
Electrical Outlets
The LCD-TV requires a GFCI receptacle in which to plug the 12-120V AC/DC adapter. Install a receptacle for this
adapter. The receptacle should be located in a readily accessible area in a dry location.
FAILURE TO DO SO MAY RESULT IN DEATH OR SERIOUS INJURY
Plug the power supply cable of the AC/DC adapter into the outlet. The power adapter is not waterproof and
therefore must be positioned in a dry, well-ventilated, accessible area away from water, moisture or heat source.
The 12V side of the AC/DC adapter powers the Northstar LCD-TV. The AC/DC adapter to the LCD-TV is fitted
with a 25' low voltage cable that should be fed behind the wall to the LCD-TV. Make sure there are two (2) feet of
extra slack at the LCD-TV to allow the power connector to be plugged into the TV for installation. The low voltage
cable should not be cut, shortened or lengthened in any way. Doing so may cause damage to the unit and voids
all warranty.
THERE'S ONLY ONE™ ELECTRIC MIRROR® | E sales@electricmirror.com | T +1 425 776-4946 | F +1 425-491-8200 | W www.electricmirror.com
3
Advertisement
