Advertisement
PART VI
HOW TO USE YOUR SHELVING
!
SHELVES POSITION ADJUSTMENT
1.
Max weight per shelf: 11 lbs ( 5 kgs )
!
2.
To adjust shelving, slide out shelf, and replace into desired position
!
!
PART VII
CARE AND MAINTENANCE
!
place for later reference.
CLEANING YOUR BEVERAGE COOLER
!
The symbols you will see in this booklet have these meanings:
WARNING
BEFORE CLEANING: Turn off the power, unplug the appliance, and remove all
items including all shelves.
• Wash the inside surfaces with warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda with a
CAUTION
quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.
• Dust the front grill and back of the unit twice yearly. Make sure the power is off before cleaning.
TIPS & INFORMATION
!
• It is recommended to clean the unit completely inside and out once a year to maximise the longevity of the Beverage Cooler.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you minimise the number of
ENVIRONMENTAL TIPS
times the door is opened. If the power is going to be off for a longer period of time, you need to take the proper steps to protect your
!
contents.
VACATION TIME
Meanings of symbols used in this manual are shown below:
Short vacations: You may leave the Beverage Cooler operating during vacations of less than three weeks.
Long vacations: If the appliance will not be used for several months, remove all items and turn off the appliance. Clean and dry the interior
!
thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
MOVING YOUR BEVERAGE COOLER
1.
Remove all items.
2.
Securely tape down all loose items (shelves) inside your appliance.
3.
Turn the adjustable leg up to the base to avoid damage.
WARNING
4.
Tape the door shut.
5.
Be sure the appliance stays secure in the upright position during transportation. Also protect the outside of the appliance with a
'flammable' and/or a small flame symbol,
!
blanket or similar item.
do not store them inside any refrigerator or
freezer. If you do so you may cause an explosion.
ENERGY SAVING TIPS
The Beverage Cooler should be located in the coolest area of the room, away from heat producing appliances, and away from direct
remove any doors. Children can suffocate if they get
sunlight.
trapped inside.
blowing gases. Avoid safety hazards by carefully
disposing of this appliance.
www.kingsbottle.com
REMOVING SHELF
WARNING
The refrigerator must be plugged into its own
dedicated 220-240V, 50Hz AC electrical outlet.
The plug must be accessible when the refrigerator is
in position.
It is essential the power point is properly earthed to
ground. Consult a qualified electrician if you are unsure.
Don't use extension cords or adapter plugs with this
refrigerator.
If the power cord is damaged, have it replaced by a
qualified service technician.
Unplug the refrigerator before cleaning it, or changing
the light bulb to avoid electric shock.
Never unplug the refrigerator by pulling the electrical
cord as this may damage it. Grip the plug firmly and
pull straight out.
Choose a location for your refrigerator that isn't too cold.
The ambient room temperature should be above 10°C.
Stand your refrigerator in a dry place – avoid areas
of high moisture or humidity.
Don't put the refrigerator in frosty or unprotected areas
like a garage or on the verandah.
Keep the refrigerator out of direct sunlight.
Don't locate the refrigerator near stoves, fires or heaters.
When installed correctly, your refrigerator should:
– Have adequate space at the back and sides
for air circulation (refer to page 9).
– Be aligned to the surrounding cupboards.
– Have doors that will self-close from a partially
open position.
WARNING
This appliance may contain a small quantity of environmentally
friendly, but flammable, non-synthetic R600a refrigerant:
damaged during transportation and installation.
8g of refrigerant. The amount of refrigerant charged in the
appliance can be found on the rating plate on the appliance.
in the built-in structure, clear of obstruction.
accelerate the defrosting process, other than those
recommended by the manufacturer.
per 8g of refrigerant. The amount of refrigerant charged
in the appliance can be found on the rating plate on
the appliance.
3
8
Advertisement
