ZyXEL Communications AMG1202-T10A Quick Start Manual page 4

Push the ZyXEL router's power switch into the
ON position.
You will see the POWER LED blink during start-
up and remain steady when ready (this takes
about 1 to 2 minutes).
Each ETHERNET LED turns on for each
corresponding port in use. (If you have no
devices connected, no lights will show).
The WLAN/WPS LED stays green when the
wireless LAN is ready, and blinks whilst
transmitting.
The DSL LED stays green when connected.
The INTERNET LED is green when internet is
available, and blinks whilst transmitting.
6
5
Step Step
Now to connect your devices.
Choose from the list below what type of device
you want to connect to the Internet, and go to
the corresponding section.
I want to connect my:
A Computer using wireless
B Computer using Ethernet cable
C Other device using wireless
D Other device using Ethernet cable p11
6
p8
p10
p11
7