Blending In A Saucepan; Turbo Button - Morphy Richards Hand Blender Set User Manual

402006_Layout 1 21/03/2013 09:43 Page 6

Blending in a saucepan

Remove the saucepan from the heat.
1.
To avoid excessive splashing, place the Blending
2.
Leg (5) into the food before switching the Hand
Blender on.
Hold the pan steady with your other hand and
3.
press the On Button (3). Use a low speed setting
to start and increase the speed as needed.
Move the Serrator Blade
4.
using a up and down motion.
Allow the Serrator Blade to stop moving before
5.
removing from the pan.
• WARNING: Lifting the Serrator Blade out of the
food while running, or using a high speed
setting in a small pan could splash hot liquid.
Extra care should be taken when using the
Hand Blender in this manner.
• Do not insert the hand blender into the food
past the join between the Main Unit
Blending Leg (5).
Using the Balloon Whisk
Insert the Balloon Whisk
Gearbox (7). Attach the whisk onto the Main
Unit (2).
To avoid splashing, select a slow speed on the
Speed Control (1)
Button (3) to start. Release the button to stop
BEFORE removing the Balloon Whisk from the
food.
6
(6) through the food
(2) and the
1 1
(8) into the Whisk
3 3
and press and hold the On
• Ensure the power cable does not touch any hot
surfaces (including the side of the pan.)

Turbo Button

• The hand blender has 8 different speeds as well
as a Turbo Button (4). Press the Turbo Button to
run the hand blender on speed 8 for intermittent
bursts.
• Note: The Chopping Bowl
only be used with the Speed Control
highest setting or when using the Turbo Button
(4). Using on a lower setting may cause
irreparable damage to the Hand Blender.
Usage
• WARNING: Your hand blender set is designed
for intermittent use. Do not use continuously for
more than 1 minute. Allow to cool down for a
minimum of 5 minutes before further use.
• Do not use continuously for more than 10
seconds when lifted out of food.
• Do not use to crush ice.
Place the Balloon Whisk into the ingredients.
Unplug from the mains before twisting the
Whisk Gearbox (7) to unlock from the Main
Unit (2). Pull the Balloon Whisk from the Whisk
Gearbox for cleaning.
(12) attachment can
(1) set to the
2
4 4