Advertisement
Steamer Module Installation
Install the Module
Remove the steamer module from its shipping carton and
discard packing materials.
Lower the steamer module into the countertop cut-out
opening. Center the module in the opening and check that
the front edge of unit is parallel to the front edge of the
countertop. Check that all minimum clearances are met.
Using a pencil, outline the rear edge of the module frame
on the countertop. Remove the module from the opening.
IMPORTANT NOTE: When repositioning the module in the
countertop opening, lift the entire unit up from the opening
to prevent scratching the countertop.
Apply the foam strip, included in the hardware package,
to the underside of the module frame. Refer to the illustra-
tion below.
Reinsert the steamer module into the countertop opening.
Align the rear edge of the module frame with the pencil
line and check that it is parallel to the front edge of the
countertop. Lift the entire module to make adjustments.
MODULE
FOAM
STRIP
Foam strip.
MODULE
COUNTERTOP
BRACKET
1
3
/
"
CLIP
2
(89)
CLAMPING
SCREW
Installation brackets.
To attach the brackets to the sides of the module, insert
the clip into the rectangular punchout in the pan and push
down. Install the clamping screw into the bracket and
tighten until the screw contacts the underside of the coun-
tertop. Do not overtighten screws. Refer to the illustration
below.
IMPORTANT NOTE: Do not seal the steamer module to the
countertop. It must be removed if service is necessary.
8
Advertisement
