Fm-Dolby Reception - Pioneer TX-9500II Operating Instructions Manual

FM-DOLBY RECEPTION
The FM DE-EMPHASIS switch is provided to allow
reception of FM-Dolby broadcasts in locations
where these programs are being transmitted. A
separately sold adaptor must be connected to the
stereo amplifier in this case, then proceed accord-
ing to the following steps.
1. As shown in Fig. 13, connect Dolby NR adaptor
to the tape (record & play) jacks of the stereo
amplifier.
2. Set rear panel FM DE-EMPHASIS switch to
2 5 ~ s .
3. Set TAPE MONITOR switch of stereo amplifier
to ON.
4. Set FUNCTION switch to FM position and use
the TUNING knob to tune in FM-Dolby broad-
cast. Tuning is performed in the same manner as
described in "FM Reception".
5. Operate adaptor and set for reception. Adjust
volume and tone with the controls of the stereo
amplifier.
NOTES:
0
Refer t o the Dolby NR adaptor operating instructions
regarding connection and operation.
When not listening to FM-Dolby broadcasts, be sure to
set the FM DE-EMPHASIS switch
to
75us.
FM DE-EMPHASIS SWITCH
1. Loosen lower screw, remove plastic cover and
set switch to 2 5 ~ s .
2. Loosen upper screw, rotate plastic cover 180"
and use this screw to secure.
DOLBY NR ADAPTOR
Fig. 13
ALLEN HEX WRENCH
The accessory Allen hex wrench is provided for
ALLEN
removing the TUNING knob or tightening its set-
screw in event it becomes loose.
If required, loosen the setscrew by inserting the
wrench into the hole on the side of the knob and
turning the wrench counterclockwise. Be particu-
TUNING
larly careful not to scratch the front panel when
employing the wrench.