Pioneer TX-1080Z Operating Instructions Manual

Operating
Instructions
SD, SD/G
FM/AM DIGITAL SYNTHESIZER TUNER
TX-10802
Y oroOmeE
if
L
STEREO AMPLIFIER
SA-1480
Thank you for buying this Pioneer product.
Please read through these operating instructions so
you will know how to operate your model properly.
After you have finished reading the instructions, put
them away in a safe place for future reference.
In some countries or regions, the shape of the power
plug and power outlet may sometimes differ from that
shown in the explanatory drawings. However, the
method of connecting and operating the unit is the
same.
WARNING: to prevent FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep it in a secure area. This is for your securi-
ty.
[For Canadian model]
CAUTION: to prevent eLectRic SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
ATTENTION: pour prevenir Les CHOCS ELEC-
TRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC
UN PROLONGATEUR UNE PRISE DE COURANT OU UNE
AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT
ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE
A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only muiti-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
Mains voltages in Saudi Arabia are 127 V and 220 V only.
Never use this model with 110 V setting in Saudi Arabia.
The line voltage selector switch is on the rear panel. Before
your model is shipped from the factory, this switch is set to
the power requirements of the destination. Check that it is set
properly before plugging the pawer cord into the AC wall
socket. If the voltage is not properly set or if you mave to
an area where the voitage requirements differ, adjust the
selector switch as follows.
1, Use a medium-size screwdriver:
2. Insert the screwdriver into the groove on the voltage selec-
tor, and adjust so that the tip of the arrow points to the
voltage value of your area.
4
Set the voltage selector
for the voltage in your area. BON hay
é > aA VOLTAGE SELECTION
Medium-size
screwdriver
Oo =
@) PIONEER'
The future of sound and vision.