Brew Group Cleaning - Saeco Energica Operating Instructions Manual

38
CLEANING

BREW GROUP CLEANING

Wash the brew group at least once a week. Before removing the group, remove the used grounds drawer as shown in fi g. 2 on page 36.
Wash the brew group with lukewarm water.
Lubricate the Brew Group every 30 days or after approximately 500 brewing cycles. The grease to lubricate the Brew Group can be
purchased at your local dealer, at the Philips on-line shop at http://shop.philips.com or at authorised service centres.
WARNING! Do not wash the brew group with detergents that may compromise its correct operation. Do not wash it in the
dishwasher.
1
Press the PUSH button to remove the
brew group.
4
Apply the lubricant evenly on both side
guides.
7
The lever on the rear part of the group
must be in contact with the group
base.
2
Wash the brew group and the fi lter and
dry.
5
Make sure the brew group is in rest
position; the two references must match.
8
Insert the washed and dried brew group.
DO NOT PRESS THE "PUSH" BUTTON.
3
Lubricate the brew group guides using
the supplied lubricant.
6
Make sure the components are in the
correct position. The hook shown must
be in the correct position; to check its
position, fi rmly press the "PUSH" button.
9
Insert the used grounds drawer
and close the service door.