Intenza Water Filter - (Optional) - Saeco Energica Operating Instructions Manual

8
INSTALLATION

INTENZA WATER FILTER - (OPTIONAL)

To improve the quality of the water you use and extend the life of your machine at the same time, it is recommended that you install the
water fi lter. After installation, go to the water fi lter initialization programme (see the "MACHINE MENU", page 25). In this way, the machine
informs the user when the water fi lter must be replaced.
Remove the water fi lter from its packaging, immerse it vertically (with the opening positioned upwards) in cold water and
gently press its sides to let the air bubbles out.
1
Remove the small white fi lter from the
tank and store it in a dry place sheltered
from dust.
4
Fill the tank with fresh drinking water up
to the "MAX" level and then place it back
into the machine.
7
ACTIVATE FILTER?
OK ESC
Press the "OK" button.
2
Set up the Intenza Aroma System:
A = Soft water
B = Medium water (standard)
C = Hard water
5
Check that the water dispensing spout is
installed (see page 6).
Place a large container under the hot
water wand.
8
INSERT FILTER.
FILL THE TANK
OK
Press the "OK" button to confi rm the
introduction of the new water fi lter.
3
Insert the fi lter in the empty tank. The
reference mark and the groove must
match. Push fi rmly until it is completely
inserted.
6
WATER MENU
ENABLE FILTER
ACTIVATE FILTER
Access the "MACHINE MENU" (see
page 25). Select "WATER MENU" and
"ACTIVATE FILTER", then press "OK".
9
INSERT WATER SPOUT
OK
Press the "OK" button to confi rm the
introduction of the dispensing spout.