Connecting The Wireless Microphone Receiver - TouchTunes Karaoke Installation And Setup Manual

Connecting the Wireless Microphone Receiver

Before proceeding, turn off the main power to Virtuo using the rocker switch on the power bar:
1. Consider the following caveats, then determine where you will be placing the wireless microphone receiver.
• The receiver should be placed in a location where patrons will not be able to access it.
• The Karaoke kit contains a 15-foot cat-5 Ethernet cable for connecting the Wireless Microphone Receiver to
Virtuo.
• The wireless microphone receiver does not require an additional power source, as power is supplied over the
ethernet cable.
• There should be no obstructions between the wireless microphone receiver and where the performers will be
positioned when singing.
• Although unlikely, the location may need to adjust the gain on the wireless microphone receiver.
2. After you select a location for the receiver, connect it to the Virtuo using the 15-foot Cat-5 Ethernet cable. The
cable connects to Virtuo's I/O board in the port labeled
3. The Cat-5 cable exits the Virtuo through its rear opening.
Connecting the Wireless Microphone Receiver
Mic 1
.
TouchTunes Karaoke Installation and Setup Guide 900587-001 Rev 03
Installing TouchTunes Karaoke 13