Recording Your Message - Talking House Transmitter Instruction Manual

Recording your message

Step Action
1 Plan out your message.
2 Make sure the Control Lock Key is inserted in the Control Lock located on the back of the Transmitter.
3
Make sure the Two-Part Message Switch located on the back panel is switched to the Part 1
Message position.
4
Make sure the TRANSMIT MODE SWITCH on the back panel is set to "Message Chip".
5
Press and hold the Record/Pause button on the front of the Transmitter until the Display Panel begins
counting down in seconds (i.e. 300, 299, 298...). NOTE: Release the Record/Pause button once you see
the count down begin.
6 Speak loudly and clearly into the hand-held microphone (or back-up microphone behind the vents
on top of the Transmitter). For best results, use the hand-held microphone.
7 To pause during recording, press the Record/Pause button on the front of the Transmitter. This will
"freeze" the counter/timer. Then, push Record/Pause again when you're ready to resume.
8 When you have completed your voice message, wait a second or two, then press and hold the Play button
located on the front of the Transmitter until you see the frequency reappear on the display panel.
9
To change the message, simply repeat steps 1-8.
5