AEG Perfekt Glide-24 Instruction Manual
Built-in range hood
Hide thumbs
Also See for Perfekt Glide-24:
- Instruction manual (17 pages) ,
- Instruction manual (17 pages) ,
- Instruction manual (20 pages)
Related Manuals for AEG Perfekt Glide-24
Summary of Contents for AEG Perfekt Glide-24
- Page 1 Perfekt Glide-24 Perfekt Glide-30 Perfekt Glide-36 Built-in Range Hood Instruc Manual Thank you for the purchase of this product. Please read the manual carefully before op g the appliance. Cod:0103079673...
- Page 2 Contents Safety Precau ons Minimum Height Safety Requirements c i f Use and Care Trouble Shoo 14-15 Diagram Warranty Informa on P a g e...
-
Page 3: Safety Precautions
Follow the cooktop manufacturer's hen replacing an existing range hood with your new AEG Perfekt Glide range hood, turn OFF the electrical power to the existing unit before removal nplug the unit before cleaning or servicing o not repair or replace any part of the appliance or attempt servicing. - Page 4 WARNING to reduce risk of cooktop grease fire: o Never leave cooking unattended at high settings. Boil- overs cause smoking and greasy spillovers may ignite. Heat oils slowly on low or medium settings o Always turn the hood on when cooking at high heat or when cooking flaming food (i.e.
- Page 5 CAUTION! Important observe all governing codes and ordinances. o For general ventilation use only. Do not use this appliance to exhaust hazardous or explosive materials and vapors o To reduce the risk of fire, use only metal duct work o To avoid damage to motor or other components, keep drywall spray, construction dust, etc.
- Page 6 CAUTION! Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examin on and/or repair Do not run cord under carpe ng. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances.
- Page 7 For the province of B h Columbia The base of the AEG insert hood is made of stainless steel and uses a stainless steel filter. There are no components on the lower side of the hood. In the housing of the motor is metal.
- Page 8 Installation Preperation Note: this procedure will require 2 people for easier in General Prepara on Remove rangehood from packaging and lay upside down on table covered with cardboard or paper to prevent scratching ofthe hood or table Be sure the power switch is setto OFF Drill 1/8”...
- Page 9 /7cm ” /4cm ”...
- Page 10 Cabinet Prepara on for Hood Support ” The range hood should be mounted at a distance of 24 ” from an electric or indu on cooktop, and 30 above a gas cooktop for safety and op mum performance. If you install the hood with a duct, you will need to provide a hole for the duct.
- Page 11 Fasten the wood strips with wood screws about 3” in from each end. NOTE: slightly more than the recessed dimension. The 2. Measure and mark the electrical wiring opening in also mark and measure the duct opening in the wall or cabinet.
- Page 12 Hood Installa on the hood to the proper po on in the cabinet x the self- tapping screw with washers. Follow the middle four holes on the top shelf inside ofthe hood. Do not damage the parts inside the hood. Connect the ductwork on the hood, using duct tape to make Power cord (length 0.9 -1.2m)
- Page 13 2 x 1W 260 CFM 6” 2 x 1W 260 CFM 6” Perfekt Glide-36 2 x 1W 260 CFM 6”...
-
Page 14: Use And Care
Use and Care Filter For highest efficiency, this filter should be removed and cleaned periodically. Soak the filter in hot water and mild soap or detergent. Rinse thoroughly and repeat if necessary. The filter may be cleaned in the dishwasher. Heavy grease buildup may not be cleaned easily, thus the filter may need to be replaced. -
Page 15: Trouble Shooting
Trouble Shooting If any problem occurs, please detach the plug from the socket and contact Euro-Parts or a similarly qualified person in order to avoid a hazard. Fan does not turn on (but light turns on). This is probably due to either a defective fan switch or a burned out fan motor. - Page 16 Light does not turn on (but fan turns on). This could be because the bulb has burned out. Try replacing the light bulb. If the light still does not work, either the light switch or the lamp-holder socket is defective. Both can be replaced without removing the range from the wall or cabinet.
- Page 17 Installa on Diagram Perfekt Glide-24 Perfekt Glide-30 Perfekt Glide-36 P a g e...
- Page 18 Tel 905-829.3980 1-800-421-6332 – Euro-Line Appliances Inc. 1-800-ELA-WEST – Euro-Line Appliances West marke ng@euro-line-appliances.com All AEG Appliances are backed by a comprehensive 2-year parts and labour warranty. Informa on on service and parts is available from Euro-Parts at 1-800-678-8352 perfek in...