Reinstalling Forever Filters; Cleaning The Negative Ion Needle - Kenmore 147 Owner's Manual

REINSTALLING FOREVER FILTERS"
1. Ensure the Pre-filter is placed in the tracks provided on
the bottom side of the Forever Filter
TM
(same side as
plastic handles).
2. Return the Forever Filters
TM
to their original position in
the air cleaner.
3. Pivot the tension clips back to their original position
_ (vertical orientation) to ensure the Forever Filter
TM
is
properly located.
4. Replace the front access panel by inserting the top
first and then push the lower outside corners toward
the rear of the cabinet until it snaps into place.
5.
After reinstalling the cleaned filters in the unit, operate
the unit in the ,Quick Dry" position for about two hours
to ensure the filter is thoroughly dry (Failure to dry the
filters may cause permanent damage to the Forever
Filters").
NOTE: If access panel does not close securely, check to
make sure that the Forever Filters are properly installed.
The plastic handles should be at the bottom.
CLEANING THE NEGATIVE ION NEEDLE
When cleaning the Forever Filters", you should also take a
cotton swab dipped in water or alcohol and wipe the two
needles located beneath the air discharge grill.
HANDLES
•7