Attaching The Dust Cover - Sony SDX-D420V Series Operating Instructions Manual

Ait drive
Table of Contents

Advertisement

Attaching the Dust Cover

18
Chapter 3 Operation
If the dust cover comes loose, attach it as described below.
Note
We recommend that you use the drive with the dust cover.
1
Align the dust cover's hinge clips (one on each side) with the pins of the
drive bezel.
• The dust cover should be positioned so that the magnets
back face the drive bezel.
*
This magnet does not affect the tape of the cartridge.
• Holding the dust cover at an angle as shown in the figure below, set the
hinge clips on top of the bezel pins, positioning them so that they
bracket the pins.
*
on the cover's

Advertisement

Table of Contents
loading

Table of Contents