Technical Data - Philips 170C7FS/00 Service Manual

4
170C7 LCD
Go to cover page
LCD
Type NR.
Number of Pixels.
Physical Size.
Pixel Pitch.
Color pixel arrangement.
Support Color.
Display Mode.
Backlight.
Active area. (WXH).
Viewing Angle (CR>=10).
Contrast ratio.
White luminance.
Type NR.
Number of Pixels.
Physical Size.
Pixel Pitch.
Color pixel arrangement.
Support Color.
Display Mode.
Backlight.
Active area. (WXH).
Viewing Angle (CR>=10).
Contrast ratio.
White luminance.
Dimension (WxHxD) *
Weight
Tilt
Main Voltage
Power cord length
Auto power saving
Scanning frequencies
Horizontal scan
Vertical scan
Power Management Definition
H- V-
STATUS
sync sync
On On On
Stand-by Off On
Suspend On Off
Off Off Off
DC Power off
Pin Assignment
Technical Data - 190C7
: LM190E08 TLB1
: 1280 (H) x1024 (V)
: 396.0(w)*324.0(h)*16.5(d) mm
: 0.294 mm x 0.294 mm
: RGB stripes arrangement
: 16.7M colors
: Normally White
: CCFL edge light system
: 376.32 x 301.056mm (19" diagonal)
: Right:80 , Left:80 , UP:75 , down:85
: 800 :1(typic
: 300 nit
: CMO M190E5 L0E
: 1280 (H) x1024 (V)
: 396.0(w)*324.0(h)*16.5(d) (Typ) mm
: 0.294 mm x 0.294 mm
: RGB vertical stripes
: 16.2M colors
: Normally White
: CCFL edge light system
: 376.32x301.056mm (19" diagonal)
: Right:85 , Left:85 , UP:80 , down:80
: 700 :1(typic)
: 300 nits
: 442 x 420 x 201 mm (incl. Pedestal)
: 5.3 kg
: -5 ~ 25°C
: AC 90 - 135 Vrms and 170 - 264 Vrms,
50/60±2 Hz
Power consumption: 40W Max.
Operating < 36W (typical), Standby < 2W.
DC power switch off < 1W.
: 1.8M
Power cord type: 3 lead with earth plug
Power indicator: LED (ON: green,
Standby: amber)
: EPA, Nutek, VESA, DPMS,
: 30 - 82 KHz
: 56 - 76 Hz
Video Power LED
Active <40W Green
Amber LCD
Blanked <1W
Amber LCD
Blanked <1W
Blanked <1W Amber LCD
N / A <1W LCD Off
Pin No. Assignment
Red video input
1
2
Green video input
3
Blue video input
4
GND
Cable detect
5
Red video GND
6
Green video GND
7
8
Blue video GND
Input DVI-D connector pin
Pin No.
1
T.M.D.S. data2-
2
T.M.D.S. data2+
3
T.M.D.S. data2 shield
4
No Connect
5
No Connect
6
DDC clock
7
DDC data
8
No Connect
9
T.M.D.S. data1-
10
T.M.D.S. data1+
11
T.M.D.S. data1 shield
12
No Connect
13
No Connect
14
+5V Power
15
Ground (for +5V) - Cable detect
16
Hot plug detect
17
T.M.D.S. data0-
18
T.M.D.S. data0+
19
T.M.D.S. data0 shield
20
No Connect
21
No Connect
22
T.M.D.S clock shield
23
T.M.D.S. clock+
24
T.M.D.S. clock-
Environmental conditions
Operating
- Temperature : 0 to 40 degree C
- Humidity : 80% max
- Altitude : 0-3658m
- Air pressure : 600-1100 mBAR
Storage
- Temperature : -20 to 60 degree C
- Humidity : 95% max
- Altitude : 0-12192m
- Air pressure : 300-1100 mBAR
Note: recommended at 5 to 35°C, humidity less than 60%.
Pin No. Assignment
9
DDC +3.3V OR +5V
10
GND
11
GND
12
Serial data line (SDA)
H-sync
13
V-sync
14
15
Data clock line (SCL)
Description