Advertisement
ASSEMBLY INSTRUCTIONS FOR PERMANENT PATIO LIGHTS
Part Numbers
PT 300-6 PM
PT 301-6 PM
PT 302-6 PM
PT 311-6 PM
PT 411-6 PM
Package Includes: Owner Manual/Assembly Instructions, 3/8 inch x
1/4 inch long set screws (2), 5/16 inch button head cap screws (2)
and allen wrench.
A 3/16 inch allen wrench is provided. You will need an adjustable-end wrench.
1. Remove all parts from carton and check against parts list. If
all parts are not located please call our toll free number -
1-800-255-2469.
2. The Patio Light base (A) is manufactured with two supply
line inlets. Please choose either the side or bottom supply
line as your fuel i nlet and remove the plug accordingly in
order to connect to gas supply. The rubber grommet (H)
provided, will protect the fuel line should you decide to use
the side supply inlet. Be certain to use thread compound
provided on gas supply connection. Section (A) should be
set in concrete a minimum of 12 inches for maximum
stability. Please allow sufficient time for concrete to set
and cure.
3. When concrete is dry and the base section (A) is secure,
proceed with Patio Lite assembly. Feed fuel supply hose
(D) through lower post section (B). Connect lower post
section (B) to base section (A) and tighten with 5/16 inch
button head cap screw (G) provided.
4. Feed fuel supply hose (D) through upper post section (C).
Insert lower post section (B) into upper post section (C)
making sure to align the set screw hole. Insert 5/16 inch
button head cap screw (G) and tighten with allen wrench
provided.
5. Connect fuel supply hose (D) to Patio Light head (E). No
pipe compound is necessary on this connection as this is a
flare fitting. Tighten with wrench.
6. Insert upper post section (C) into Patio Light head collar (E).
Insert the 3/8 inch x 1/4 inch set screws (F) and tighten
with allen wrench provided.
Flame Engineering Inc. • PO Box 577 • LaCrosse KS 67548 • 800-255-2469 • 785-222-2873 • 785-222-3619 Fax • www.FlameEngineering.com
Parts List
A. Patio Light Base w/ Pipe Insert
B. Lower Post Section w/ Cuff
C. Upper Post Section
D. Fuel Supply Hose - connected to A
E. Patio Light Head w/valve
F. (2) 3/8 inch x 1/4 inch Set Screws
G. (2) 5/16 inch Button Head Cap Screws
H. Rubber Grommet
I. (2) Pipe Compound Capsule
F
D
C
B
H
A
Bury Below Ground
Level 12" Minimum
Remove Plug If Fuel
Source Will Connect Here
7. When installation is complete, open gas supply valve and
test all gas connections with soapy water before lighting.
Do not use a match or open flame to check for leaks.
Correct all leaks and test with soapy water before lighting.
SEE THE BACK PAGE FOR INSTALLATION PLUMBING EXAMPLES.
LIGHTING INSTRUCTIONS
Turn all valves to an off position. Head valve must be turned
clockwise to be in an off position. Open source/cylinder valve
slowly, open head valve slightly and light with a long grill or
fireplace lighter. Adjust to desired flame using head valve. DO
NOT LEAVE UNATTENDED. When Patio Light is not in use,
be sure source/cylinder valve is closed.
E
Valve
F
G
G
Remove Plug
If Fuel Source
Will Connect Here
Advertisement
