Advertisement
ASSEMBLY INSTRUCTIONS FOR PORTABLE PATIO LIGHTS
A
Valve
3/8" x 1/4"
Set Screws
B1
5/16" Button Head
Cap Screw
B2
C
1. Remove parts from carton and check against parts list. If all
parts are not located please call our toll free number -
1-800-255-2469.
2. Assemble axle (E) and both wheels (D) on cart frame (C).
Be sure extended side or hub of wheel (D) is toward cart
frame (C). Place axle caps on outside of wheels. Firmly tap
axle caps with hammer.
3. Feed the 3/8 inch female flare fitting of hose through the
hole in the side of the lower post section (B2) and on
through the upper post section (B1). Connect 3/8 inch
female flare fitting to the 3/8 inch male flare fitting located
on the Patio Light head (A). Tighten the connection with a
wrench (no need for tape or pipe compound).
4. Insert upper post section (B1) into Patio Light head collar.
Insert 3/8 inch x 1/4 inch set screws (2) tighten securely
with allen wrench. Insert lower post section (B2) into upper
post section (B1) making sure to align set screw hole.
Insert 5/16 inch button head cap screw and tighten with
Flame Engineering Inc. • PO Box 577 • LaCrosse KS 67548 • 800-255-2469 • 785-222-2873 • 785-222-3619 Fax • www.FlameEngineering.com
F
5/16" Button Head
Cap Screw
D
Part Numbers
PT 300-6 C
PT 301-6 C
PT 302-6 C
PT 311-6 C
PT 411-6 C
Package Includes: Owner Manual/Assembly Instructions, Cylinder
Strap, Axle Caps (2), 3/8 inch x 1/4 inch long set screws (2), 5/16
inch button head cap screws (2) and allen wrench.
You will need: Hammer & an adjustable end wrench.
D
allen wrench. Place assembled post and head into post
cuff of cart frame (C). Be sure to align the set screw hole.
Gently pull hose through exit hole to prevent kinking. Insert
button head cap screw and tighten with allen wrench.
5. Position cylinder on cart frame (C) and secure with
enclosed strap. Attach inlet fitting (P.O.L.) to cylinder. This
is a left handed fitting and requires no pipe compound.
CLOSE HEAD VALVE. Head valve must be turned
clock-wise to be in an off position. Using soapy water,
open cylinder valve slowly and check all connections for
gas leaks. Correct any leaks before using. This testing
procedure should be done once a month.
LIGHTING INSTRUCTIONS
Turn all valves to an off position. Head valve must be turned
clockwise to be in an off position. Open source/cylinder valve
slowly, open head valve slightly and light with a long grill or
fireplace lighter. Adjust to desired flame using head valve. DO
NOT LEAVE UNATTENDED. When Patio Light is not in use,
be sure source/cylinder valve is closed.
Parts List
A. Patio Light Head w/ valve
B1. Upper Post Section
B2. Lower Post Section w/ Cuff
C. Cart Frame
D. Cart Wheels (2)
E. Axle
F. Hose, Regulator and POL
E
C
Cart Rear View
Axle Caps
D
Advertisement
