Table of Contents
Advertisement
Check battery
Check air in tires (6 to 8 lbs.)
Check engine crankcase oil
Drain engine crankcase oil
Check transmission oil (add to filler plug level as
needed)
Check cooling air screen
Lubrication points (see lubrication guide)
Check generator-starter mounting bolts
Check for belt wear
* Varies depending on operation conditions, climate etc.
LUBRICATION
Proper lubrication and regular maintenance will
increase the operating life of your HUSKY and
attachments. Negligence on the part of the operator in
regard to lubrication or general maintenance can
LOCATION
1. Wheel Bearings
2. Front Wheel Spindles
3. Front Axle Pivot
4. P.T.O. Housing
5. Air Cleaner
*6. Speed Lock Pivot
*7. Disc Brake Linkage
•*8. Hydrostatic
Transmission
9. Transmission Filter
10. Hood Hinge
11. Generator-Starter
*12. Universal Joints
13. Pivot Shaft
*14. Speed Control Pivot
*15. Engine Crankcase
• capacity 10 quarts. See your dealer for specified oil for complete refills.
* More frequent if application demands.
NOTE: Hand type grease gun recommended when greasing your unit. Hi-pressure type grease guns could cause
damage to the fittings. Lubricate all linkages, levers and pins not equipped with grease fittings with an oil can weekly.
MAINTENANCE GUIDE
AFTER EVERY 10
OPERATION
TYPE OF
LUBRICATION
Wheel Bearing Grease
Gun Grease
Gun Grease
Gun Grease
Oil
Oil
Automatic Transmission
Fluid Type A
Oil
No lubrication require
Gun Grease
Gun Grease
Oil
PAGE 10
AFTER EVERY 25
HOURS OF
HOURS OF
OPERATION
X*
X*
See Engine Manufacturer's Manual
X
X*
X*
X
X
depreciate the dependability of this rugged and durable
vehicle. It is suggested that lubrication recommendations in
this manual be followed. A lubrication schedule prepared by
the operator would be beneficial.
The numerically listed locations on the lubrication chart
correspond to those numbers shown on Figures 19 and 20.
AMOUNT OF
LUBRICATION
Pack
As Req'd.
As Req'd.
As Req'd.
See Engine Manufacturer's Manual
Coat surfaces
Coat surfaces
Add to plug level
Coat surfaces
One stroke of grease gu n
One stroke of grease gun
Coat surfaces
See Engine Manufacturer's Manual
AFTER EVERY 50
HOURS OF
OPERATION
X*
FREQUENCY
OF LUBRICATION
Once a year
10 hrs.
10 hrs.
10 hrs.
25 hrs.
25 hrs.
Check once a week or 25 hrs.
Change every 300 hrs.
or with oil change
25 hrs.
8 hrs.
8 hrs.
25 hrs.
Hide quick links:
Advertisement
Table of Contents
