WisyCom CRT 16 Manual page 2

11)
Transmission button - green: secondary transmission frequency (TX2).
In standard preset, the button operation is the same as for the main transmission button. The transmission frequency
can be selected using the TX2 rotating switch [13].
If the DRX option (dual channel receiver) is present and enabled, a single pressure on this button syntonize the
receiver to the secondary channel, which is next respect the selected one with the rotating switch RX [15]. The
received channel indicator [14] becomes green.
The DRX option, when present, can be enabled/disabled by keeping pressed the green button for a second while the
unit is turned-on, then releasing it. The selected working preset will be saved in the internal memory.
12)
Screwdriver selector: transmitter's main frequency (TX1).
13)
Screwdriver selector: transmitter's secondary frequency (TX2).
14) Led indicator (red / green): selected receiver channel indicator (only with DRX option).
If the receiver's channel led indicator [14] is turned off, or if the DRX option is enabled and the led is red, the
received channel is the selected one. If the led is green, the received channel is the next respect the selected one.
15) Screwdriver selector: receiver's frequency (RX).
16) Compartment for the battery-pack. CRT16 is powered by an interchangeable battery-pack, with nr. 4 - size-AA
elements, either alkaline or rechargeable Ni-Mh, that can be separately recharged using Wisycom ACM16 charger.
A slide-selector in the battery compartment must be pre-set according to the chosen power source.
Note: A belt-clip is placed on the back side of the unit that can be easily removed with a screwdriver.
WISYCOM S . r . l .
• Via Spin, 156
Tel. +39 0424 382605 •
• I-36060 Romano d'Ezzelino (VI)
Fax +39 0424 382733 •
• Italy
www.wisycom.com • e-mail: sales@wisycom.com
CRT16-1-eng.doc