Installation Steps - Nuvo h2o Installation Manual

INSTALLATION STEPS

For Home System and Studio System
1. Turn off main water supply line leading to the water treatment system.
2. Attach Wall Mounting Panel horizontally to wall studs with provided
screws. Note: Do not attach bottom screw at this time.
3. Attach C-Bracket horizontally to Wall Mounting Panel under "Softener"
label. Note: Right screw should go through right hole on C-Bracket and the
lower right hole on Wall Mounting Panel into the right wall stud.
4. Remove Housing Head from Housing Body by detaching the Collar (turn
counterclockwise or left - use provided Wrench if necessary).
5. Attach the appropriate nipple (not included) securely into the ports on
each side of Housing Head. Properly attach the inflow and outflow to
the inlet and outlet ports in the Housing Head as marked.
6. Attach Housing Head to wall by inserting the nipples in Housing Head
through the side holes in the C-Bracket. Note: Softener must hang
vertically.
7. Securely connect water supply line inlet & outlet to nipples in Housing
Head (connecting pipe not included).
8. Check proper seating of O-ring inside Housing Body.
9. Using the Wrench provided, securely tighten Housing Body to housing
Head by attaching the Collar (turn clockwise or right).
10. Turn on water and check for leaks.
11. If leaks occur, confirm that Housing Body is securely attached to
Housing Head using Wrench to tighten Collar.
12. If leaks persist, turn off water, remove Housing, and repeat Steps 8-12.
5