Figure 23: Satellite Heater Jumper Setting - Roberts Gorden Energytube EM-115 Nstallation, Operation And Service Manual

SECTION 10: W
IRING
10.3.2 Satellite Heater Configuration
Satellite heater configuration is set by positioning of
jumpers on pin block J10 located on the control board
inside the heater compartment, See Page 43, Figure
23. Jumper position on J10, shown on Page 43,
Figure 23 will configure heater as a satellite heater.
(The jumper position for satellite is the same as the
jumper position of a central heater using a zone
sensor). Jumper on J9 may be left alone.

FIGURE 23: Satellite Heater Jumper Setting

43 of 71