KVH Industries TracVision TV3 Installation Manual page 16

11 Continued
DIRECTV – SWM Wiring
Follow these steps to connect DIRECTV SWM
receivers to the TracVision system (circular LNB
and TV-Hub A required).
NOTE: You can connect non-SWM receivers as well,
as explained in "DIRECTV – Non-SWM Wiring" on
page 17.
Connecting 1 SWM Receiver
Connect an RF cable from the "SWM" jack on the
TV-Hub to the "Satellite In" jack on the receiver/
DVR (see Figure 26).
Connecting 2-8 SWM Receivers (or Tuners)
a. Connect an RF cable from the "SWM" jack on
the TV-Hub to the "SWM" input on the SWM
splitter (supplied in the kit) (see Figure 27).
b. Connect the SWM splitter's outputs to the
"Satellite In" jack on the receivers/DVRs (or
"Network" jack when connecting a Genie
client). You can connect any number of SWM
and Genie devices that add up to 8 tuners or
fewer. Refer to Figure 27 to determine the
tuners consumed by each type of device.
c. Terminate any unused outputs on the SWM
splitter with the supplied 75terminators
and verify all connections are tight.
IMPORTANT!
If you need to receive local channels on the
119W satellite, and you want the antenna to
automatically switch between the 101W and
119W satellites, you need to use the DIRECTV
coax network. See Appendix B on
details.
Wire the Receivers
Figure 26: Wiring 1 DIRECTV SWM Receiver
TV-Hub
Figure 27: Wiring a DIRECTV SWM Splitter
TV-Hub
Terminate
unused
outputs
page 34 for
RF1
SWM
Satellite In
SWM
Supports up to 8 tuners:
Each SWM receiver = 1 tuner
Each SWM DVR = 2 tuners
Each Genie DVR = 5 tuners
SWM Splitter
Each Genie client = 0 tuners
Satellite In
Satellite In
Satellite In
COMPONENT VIDEO OUT
Y Pb Pr
SATELLITE IN 1
L R
IR RECEIVE ETHERNET VIDEO OUT AUDIO OUT S-VIDEO OUT
Genie Client
Network
Genie Client
Network
Genie Client
Network
Antenna
SWM Receiver
AC Power
SWM Receiver
AC Power
SWM DVR
AC Power
Genie DVR
DIGITAL
AUDIO OUT
POWER INPUT
SATA HDMI USB PHONE JACK
AC Power
Note: Although you
may connect
additional Genie
clients, only 3 can be
active at one time
15