KVH Industries TV-series Quick Start Manual

How to Turn On the System

Note: Only TV-Hub A includes these
connectors for North American services.
TV-Hub B does not require them.
TV-Hub
Power Switch

How to Access the Web Interface

TV-Hub
IP address (wired direct):
169.254.253.1

How to Select the Master Receiver

©2014 KVH Industries, Inc., All rights reserved. KVH, TracVision, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are the property of their respective companies. The information in this document is subject to change without notice. No company shall be liable for errors contained herein.
TracVision
®
This guide provides basic operation and troubleshooting information for the TracVision
TV-series satellite TV antenna systems. For complete operation, setup, and diagnostics
information, refer to the system's comprehensive Help Center, available on the TV-Hub's
web interface. If you need any assistance, please contact KVH Technical Support.

Technical Support

North/South America, Australasia:
Phone: +1 401 847-3327
E-mail: support@kvh.com
At the rear panel of the TV-Hub, set the power switch to the On
position. The TV-Hub supplies power to the antenna. Wait a
few minutes for system startup.
You can access the web interface using any Wi-Fi-enabled
mobile device (such as a smartphone, tablet, or laptop).
1. Select the TVHub-<TV-Hub serial number> network from
2. Start your web browser and enter http://tvhub.kvh.
If your system is set up for automatic satellite switching with
multiple receivers, you can select the master receiver on the
Home page of the web interface. The master receiver controls
satellite selection.
54-0989 Rev. A
TV-series Quick Start Guide
Europe, Middle East, Africa, Asia-Pacific:
Phone: +45 45 160 180
E-mail: support@emea.kvh.com
The antenna requires a clear view of the sky. Objects such as
bridges and boat masts can block satellite signals.
your device's Wi-Fi settings to connect to the TV-Hub.
If the TV-Hub is connected to an onboard network, you may also
access the web interface over the network by entering the
TV-Hub's IP address in your browser. (You can find the IP
address on the Settings page of the web interface.)
If the receiver is equipped with an IP AutoSwitch, you may also
press the button on the IP AutoSwitch to make it the master.