Potterton Prorile Prima 30e Installation And Servicing Instructions page 14

INSTALLATION INSTRUCTIONS - Page 14
LIFTING THE BOILER
Lift the boiler onto its mounting bracket
FIG !4
Locate the studs on the air duct flange through the boiler
casing and secure using four wing nuts (accessory pack
F).
FIG. 16 SECURING BOILER
Rotate the left hand adjustment screw to align one of the
holes in the base plate with hole 'D' in the wall. Working
through the hole in the leg, secure the base plate to the
wall using the screw from accessory pack D. Make good
the wall surface around the flue terminal. Fit optional
terminal wall plate if required.
FIG 15
Position boiler on its mounting bracket so that the sides of
the boiler line up with the reference lines 'C' on the rear
wall
Undo the two screws securing the transportation foot and
discard foot. Vertical alignment with rear wall can be
corrected using the adjustment screws at the rear of the
boiler. See FIGS. 15 & 16.
FIG. 17
If the fan/ fluehood assembly or burner/gas control
assembly were removed to reduce the appliance lift weight,
refit them to the boiler. Reassembly is the reverse of
removal. When refitting the burner/gas control assembly
ensure that the locating pin on the rear of the burner
engages correctly into the rear support bracket.
When refitting the fan/ fluehood assembly ensure that the
rear of the fluehood is correctly located beneath retaining
flange. See FIG. 17.