How To Maintain - Eureka 160 Series Owner's Manual

A
B
10
C
F
D
E
G
ENGLISH

HOW TO MAINTAIN

The instructions given in this booklet serve as a guide to routine
maintenance. Keep the cleaner operating at top efficiency. Empty
the dust cup after each use.
Empty Dust Cup
Note: Turn off the power switch and unplug the electrical
cord to service.
Step 1: Slide dust cup latch
Step 2: Pull dust cup B
nozzle.
Step 3: Pull filter C out of dust cup.
Step 4: Shake and brush the dust and dirt from filter
waste container. (To clean filter refer to dust cup filter
section).
Step 5: To replace dust cup
E
.
Step 6: Gently squeeze the sections together until the dust cup
F
latch locks the cup in place.
Clean Dust Cup Filter
Note: Turn off the power switch and unplug the electrical
cord to service.
Clean the dust cup filter as necessary.
Step 1: Remove dust cup.
Step 2: Pull dust cup filter
Step 3: Shake and brush the dust and dirt from filter
Step 4: If desired, launder the filter
using a mild detergent.
Note: The dust cup filter is not dishwasher safe. Do not put in
diswasher.
Step 5: Air dry thoroughly.
Step 6: Replace filter G
in dust cup by pushing the seal located at
the top in firmly to ensure proper filter performance.
Replace a dirty or torn filter. Order additional dust cup filters
from The Eureka Company, Bloomington, IL 61701. Order dust
cup filter, part number 61544. To place an order please tele-
phone 1-800-282-2886.
Clean Brush Roll (on some models)
Note: Turn off the power switch and unplug the electrical
cord to service.
The brush roll turns to sweep and comb the carpet nap. Keep the
brush roll free from hair and threads so it will continue cleaning.
A up.
from handle section and lift from the
D
, fit dust cup down into the nozzle
G
out of dust cup.
G
G
by hand in warm water
C into
.