Jeep 1997 Grand Cherokee Service Manual page 2063

SPEEDOMETER OUTPUT SHAFT SEAL TRANSFER CASE ADAPTER INSTALLER 6952–A PRYBAR
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 6 Location Of Index Numbers On
SpeedometerAdapter
Fig. 7 Remove Front Output Shaft Seal
(b) Start seal in bore with light taps from ham-
mer (Fig. 8). Once seal is started, continue tapping
seal into bore until installer tool seats against case.
Fig. 8 Front Output Seal Installation
INDEX NUMBER LOCA- TION SPECIAL TOOL MD998056–A
TRANSMISSION AND TRANSFER CASE
DISASSEMBLY AND ASSEMBLY
NV242 TRANSFER CASE
DISASSEMBLY
REAR RETAINER REMOVAL
(1) Remove output shaft boot. Spread band clamp
that secures boot on slinger with a suitable awl.
Then slide boot off shaft (Fig. 9).
(2) Using puller MD-998056-A, remove rear slinger
(Fig. 10).
(3) Remove slinger stop spacer and snap-ring from
output shaft (Fig. 11).
(4) Remove rear seal from retainer (Fig. 12). Use
pry tool, or collapse seal with punch to remove it.
(5) Remove rear output bearing I.D. retaining ring
(Fig. 13).
(6) Remove speedometer adapter.
(7) Remove rear retainer bolts.
TRANSFER CASE TRANSFER CASE SLINGER SLINGER BOOT AWL
Fig. 9 Output Boot—Typical
Fig. 10 Rear Slinger Removal
21 - 129