Reference; Ekko Projector Adapter Interfaces - Newnham Research EKKO Projector adapter User Manual

NR-05-0001/1.0

3 Reference

3.1

EKKO Projector Adapter Interfaces

Figure 3 – EKKO Projector Adapter viewed from VGA connector end
Figure 4 - EKKO Projector Adapter viewed from Network connector end
As shown in Figure 3 and Figure 4, the EKKO Projector Adapter has 3 external connectors (POWER,
VGA and NETWORK), 4 indicator LEDs and a Kensington Security Slot.
3.1.1 Connectors
The power socket should only be connected to the power unit supplied for the purpose.
VGA output is via a standard 15-pin D connector. This should be connected directly to the projector.
The VGA connector may be plugged and unplugged while the device is working. The length of the
cable should not exceed 5m.
The network is connected via an RJ-45 socket. This should be connected to a 10/100 hub or switch via
a good quality CAT5 UTP cable.
3.1.2 Indicators
The EKKO Projector adapter has four indicators, two on the network socket and two on the end panel.
Network Link indicator
This is a green LED on the right of network socket. This will light when the device is linked to a
remote network device.
Newnham Research Ltd
Client Status (Yellow)
Idle Status (Green)
VGA Connector
Network Activity (Yellow)
Network Link (Green)
Power
Kensington Security Slot
page 11 of 15
User Guide