Page 1
Division electric heater. Please read carefully before installing and using your heater. However, if further information is required, our Baxi Fires Division Technical Helpline will be pleased to help. Telephone 08706 061 065 (National call rates apply in the United...
British Standards and Safety Marks. Quality and Excellence. All Baxi Fires Division heaters are manufactured to the highest standards of quality and excellence and are manufactured under a BS EN ISO 9001 quality system accepted by the British Standards Institute.
INSTALLER AND OWNER GUIDE HANDLING AND UNPACKING The ‘Distinction’ model is supplied with the fascia fitted to the heater. We recommend that this is removed before continuing with the installation. To do this, remove the two thumbscrews at the base of the heater, pull the bottom of the fascia forward and lift the fascia clear of the heater.
Always use a fireguard when young children, infirm persons and pet animals can come into contact with the heater. Always use genuine Baxi Fires Division spare parts. Never Never leave children unsupervised in a room where the heater is ON and unguarded.
Page 6
INSTALLER AND OWNER GUIDE FITTING THE HEATER The installation of this heater requires a reasonable level of DIY skills. Please read this guide thoroughly before commencing installation and if in doubt, seek help from a competent person. Do I need any tools? Hanging Deco and Distinction models.
Page 7
INSTALLER AND OWNER GUIDE Important! This heater must be earthed. The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm² 3 core cable. The wires in the cable are coloured in accordance with the following code: - Live =Brown Neutral = Blue Earth = Green / Yellow...
Page 8
INSTALLER AND OWNER GUIDE Fitting the heater. Hanging Deco and Distinction models. 1. There is a Lower Support bracket supplied with the heater. Secure this to the rear base of the heater with the two screws supplied (See figure 3). 2.
Page 9
INSTALLER AND OWNER GUIDE 8. Underneath the heater, mark on the wall the position of the slot in the lower support bracket. 9. Lift the heater off the wall. 10. Drill the marked positions using a suitable sized drill bit for the chosen fixings.
INSTALLER AND OWNER GUIDE Fitting the Distinction Fascia. 1. Fit the fascia and secure using the thumbscrews removed previously. Fitting the Fuel support (All models). 1. Locate the fuel support as in figure 7. 2. Place the coals on top of the fuel support. It is not necessary to use all the coals supplied.
INSTALLER AND OWNER GUIDE CLEANING AND MAINTAINING THE HEATER How do I clean my heater? The heater fascia and plastic parts need only to be wiped clean with a dry soft cloth, do not use polishes or abrasive materials. The ‘Distinction’ fascia is NOT glass fronted and will be damaged by the use of polishes or abrasive materials.
Page 12
4. I Have a problem that is different to those in the previous examples 1- 3. Following is a list of useful telephone numbers For general advice about your heater: BAXI FIRES DIVISION TECHNICAL HELPLINE 08706 061 065. To report faults or arrange for your heater to be serviced: BAXI FIRES DIVISION SERVICE 08706 090 081.
INSTALLER AND OWNER GUIDE What should I do when I’m ready to dispose of my heater? The plug should be removed from the mains supply cable and the mains supply cable cut from the heater. Environmental Protection. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.