Lindy 38119 User Manual page 4

User Manual
Installation
Important! Before starting the installation, please ensure that all devices are powered off.
The following steps are for an installation using HDMI equipment, if you are using DVI
equipment, please substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the HDMI Extender Transmitter unit using a HDMI cable
(maximum length 5m).
2. Connect one end of the Cat.5e/6/7 cable (max. length 100m) to the HDBaseT port on the
Transmitter and the other end to the HDBaseT port of the Receiver. Use solid core
installation cable of at least Cat.5e UTP.
3. Use another HDMI cable (maximum length 5m) to connect your HDMI display device to the
HDMI output port on the Receiver unit.
4. For additional Infrared remote signal functionality, connect the included IR Extension Cables
to the Transmitter and Receiver units.
5. At the Transmitter side, place the IR Eye in front of the HDMI source devices IR receiver. At
the remote side, place the IR Eye in a location where it may easily receive the signal of your
IR remote.
6. For Ethernet functionality, connect your devices to the 10/100Base-T ports.
7. Plug the DC power supplies into the Transmitter and Receiver units and switch on.
8. Power on your HDMI Source and Display to complete the installation.
Troubleshooting
There is no display on the screen.
 Check that the DC plug and jack used by external power supply are firmly connected.
 Check that the Cat.5e/6/7 cable is plugged in correctly and that the Link Status LED is lit.
 Check that the HDMI source and display are both powered on and active and that the HDMI
LED is Lit.
 Power off all the devices, then power on in this order: first, the transmitter unit, then the
display and finally the source.
 For several HDMI devices it may be helpful to unplug and replug their HDMI connection to
re-initiate the HDMI handshake and recognition.
 Reduce the length of Cat.5e/6/7 or HDMI cable used, or use a higher quality cable.
2
English