Advertisement
•
Do not insert or allow foreign objects to
pass through the inlet or outlet openings.
This may cause an electric shock, fire or
damage the heater.
•
To prevent a possible fire or heat damage,
allow ample space around the heater (at
1.7m at front and 0.5m at the rear, top and
sides) and do not totally or partially block
the air inlet or outlets in any manner.
Check the openings from time to time for
accumulated dust. Ensure long shag carpet
does not obstruct airflow under the unit.
•
Do not touch hot metal surfaces.
•
Switch off at the control switch and
power outlet, then unplug and allow
heater to cool down before cleaning or
storing.
•
Use this heater only as described in this
instruction manual. Any other use not
recommended by the manufacture may
cause fire electric shock or injury and
voids all warranties.
•
Regularly inspect the supply cord, plug,
control settings, air inlets and outlets and
main housing for any damage. If found
damaged in any way, immediately cease
use of the heater and return to Kambrook
or an authorised service agent for
inspection or repair.
•
The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit. See your
electrician for professional advice.
HOW TO OpeRaTe
Remove your heater from its carton and
associated protective wrapping, and unwind
the cord to its full length and remove any
protective cardboard or foam that may
have been used to minimize transportation
damage.
Remove any element supports Guards (ie
foam or paper packing) by removing the
front guard screws , lift the guard outwards,
support and remove element supports.
Return the guard to the normal position and
replace screws.
Remove the warning sticker from the front
grill.
Read and follow the complete instructions
before plugging the unit into the 230-240 Volt
supply.
Remove the castors from their storage
position on the base and using the same
securing screws, fit the castors so that they
are positioned on the outer-most securing
holes on the base of the heater. The heater
must never be operated without the castors
secured in the correct position as shown
(Figure 1).
Place the heater on a level surface in a stable
position. Make certain the heater element
control switch is in the OFF position.
Please ensure that wheels are mounted
before use.
Inside your box you will find two (2) sets
of wheels and four (4) wing nut sets. To fit
wheels to heater please turn heater up side
down on an even surface. Four (4) screws are
prefixed to the bottom of the heater simply
align the wheel sets onto the screws and
fit the four (4) wing nut sets to the screws,
tighten by hand only.
Plug the power cord into a 240 Volt outlet,
the red indicator light will illuminate when
the power outlet is switched on.
Use the switch settings on the top housing
of the heater to switch the heater to the
desired setting.
Advertisement
