Anti Tamper Alarm; Sound And Light Indication; Detailed Programming Guide - SIB Standalone Keypad Access Control User Manual

9. Anti Tamper Alarm

The unit uses a LDR (light dependent resistor) as an anti tamper alarm. If the keypad is
removed from the cover then the tamper alarm will operate.

10.Sound and Light indication

Operation Status
Power on
Stand by
Press keypad
Operation successful
Operation failed
Enter into programming mode
In the programming mode
Exit from the programming
mode
Open the door
Alarm

11. Detailed Programming Guide

11.1 User Settings
To enter the programming mode
To exit from the programming mode
Note that to undertake the following programming the master user must be logged in
To change the master code
Setting the working mode:
Set valid card only users
Set valid card and PIN users
Set valid card or PIN users
To add a user in either card or PIN mode, i.e. in the 3
To add a Pin user
Red Light Green Light
- Bright
Bright -
- -
- Bright
- -
Bright -
- -
Bright -
- Bright
Bright -
* Master code #
999999 is the default factory master code
*
0 New code
The master code can be 6 to 8 digits long
3 0
3 1
3 2
1 User ID number
6
Yellow Light
-
-
-
-
-
-
Bright
-
-
-
# New code #
# Entry is by card only
# Entry is by card and PIN together
# Entry is by either card or PIN (default)
2 # mode. (Default setting)
# PIN #
Buzzer
Di
-
Di
Di
DiDiDi
Di
Di
Di
Alarm