Packing List; Quick Reference Programming Guide - SIB Standalone Keypad Access Control User Manual

Please read the manual carefully before use this unit

1. Packing List

Name
Keypad
User manual
Screw driver
Rubber plug
Self tapping screws
Star screws
Please ensure that all the above contents are correct. If any are missing please notify the
supplier of the unit.

2. Quick Reference Programming Guide

To enter the programming mode
To exit from the programming mode
Note that to undertake the following programming the master user must be logged in
To change the master code
To add a PIN user.
To add a card user
To delete a PIN or a card user.
To unlock the door for a PIN user
Quantity Remarks
1
1
Φ20mm×60mm,Special for keypad
1
Φ6mm×30 mm
2
Φ4mm×28 mm
2
Φ3mm×6mm,
1
*
Master code
999999 is the default factory master code
*
0
New code
The master code can be 6 to 8 digits
1 User ID number
The ID number is any number between 1 & 2000. The
PIN is any four digits between 0000 & 9999 with the
exception of 1234 which is reserved. Users can be added
continuously without exiting programming mode
1 Read Card
Cards can be added continuously without exiting
programming mode
2 User ID number
2 Read Card
Users can be deleted continuously without exiting
programming mode
Enter the PIN then press #
2
, used for fixing
, used for fixing
used for fixing
#
# New code #
# PIN #
#
# for a PIN user or
# for a card user