[2] SPECIFICATIONS 2. Printer driver functions (1) Windows driver functions 1. Printer specifications a. General Memory capacity Standard 128MB PPD file *1 Function PCL5e PCL6 (standard) (for Windows XP) DIMM slots for One (128 MB to 256 MB memory can be Copies 1-999 additional memory...
Page 6
b. Paper Input d. Graphic PPD file *1 PPD file *1 Function PCL5e PCL6 Function PCL5e PCL6 (for Windows (for Windows XP) Paper size A3 / B4 / A4 / B5 / Resolution 600/300 dpi 600dpi 600dpi A5 / Ledger / setting Legal / Foolscap / Halftone...
Page 7
(2) Macintosh driver functions c. Paper output a. General Macintosh PPD file Function (for Mac OS X ver10.2.8) Macintosh PPD file Function Output tray Center tray (for Mac OS X ver10.2.8) selection Finisher Copies 1-999 • Top tray Orientation Portrait •...
Page 8
(4) Printable area f. Others The print area of this product is shown below. Macintosh PPD file Function (for Mac OS X ver10.2.8) Configuration setting Watermark Form overlay Print hold Confidential print (PIN selection) Sample print Print accounting Quick sets Auto configuration No (OS9: Yes) Job end notification...
[3] INSTALLATION 1 AR-NC7 installation <Before installation> • To enable the network function, the product key must be acquired. (For the method of acquiring the product key, contact the dealer.) Parts included (1) Turn off the switch of the main unit.
Page 10
(4) Reattach the control PWB unit. 2) Remove the five screws that secure the control PWB unit to the main unit. 1) Reattach the control PWB unit to the main unit. 3) While holding the two handles, pull the control PWB unit out 2) Reconnect the flat cable connector that has been removed in until the stopper is engaged.
Page 11
(2) Remove the control PWB unit. 3) According to the customer’s network environment, install the printer driver software using the supplied CD-ROM. 1) If cables are connected to the control PWB, remove all cables. For installation of the driver software to the computer and server and its setting, follow the installation guide.
Page 12
(5) Remove the right cabinet of the main unit and the 2) Remove the screws that secure the cover and remove the cover. HDD cover. Then, insert the connector of the print server card to the con- • If the saddle finisher or the like is installed at the right side of the nector of the control PWB unit.
Page 13
(8) Turn on the main switch of the main unit. 3. AR-PK6 installation 1) Insert the power plug of the main unit to the outlet. <Before installation> 2) Turn the main switch of the main unit to the “ON” position. •...
[5] SETTING 1. Key operator program Level 1 Level 2 Level 3 PROHIBIT NOTICE PAGE PRINTING PRINT DENSITY LEVEL DEFAULT SETTINGS PROHIBIT TEST PAGE PRINTING A4/LETTER SIZE AUTO CHANGE HEXADECIMAL DUMP MODE PRINTER SETTINGS I/O TIMEOUT ENABLE PARALLEL PORT PARALLEL PORT EMULATION SWITCHING ENABLE USB PORT INTERFACE SETTINGS USB PORT EMULATION SWITCHING...
Page 16
Parallel port emulation switching IP address setting This program is used to specify a printer language to emulate when When using this product in a network that uses the TCP/IP proto- the printer is connected to a computer through the parallel port. col, use this program to set the IP address (IP address, IP subnet mask, and IP gateway) of this product.
[6] SIMULATION 67-11 Purpose Setting 1. List Function Used to set YES/NO of the parallel I/F select (Purpose) signal of the printer. Code Section MFP controller Function (Purpose) Main Item Operation Interface/Communication Used to check the operation of the parallel I/F of Operation/Procedure the printer.