Remote Control Programming - Ready Remote 24921 Owner's Installation Manual

Remote Control Programming

Turn key to the ON position
1.
2. Within 5 seconds, press and release Control button one time.
Within 5 seconds, press and hold the Control button. The LED will
3.
flash one time to confirm entry into remote programming.
Press the button on the remote control.
4.
5. The LED flashes to confirm the remote has been programmed.
Release the Control button, and turn the key to the Off position.
6.
7. The LED turns on solid for a while to confirm that remote program-
ming has been exited.
The programming routine exits if any of the following occurs:
• The ignition is turned off
• There is no activity for 30 seconds
• The Control button is pressed too many times
10
© 2010 Directed Electronics. All rights reserved.