Honda 2005 Accord Owner's Manual page 234

Main Menu Table of Contents
Lights
5. Remove the burned out bulb from
the socket by pushing it in and
turning the bulb counterclockwise
until it unlocks.
6. Install the new bulb in the socket.
Turn it clockwise to lock it in place.
Insert the socket back into the
7.
headlight assembly. Turn it
clockwise to lock it in place.
8. Turn on the lights to make sure
the new bulb is working.
Put the inner fender cover in place.
9.
Install and lock each holding clip
by pushing on the center.
232
Replacing Rear Bulbs
COVER
1. Open the trunk.
Remove the light assembly cover
by pulling its outside edge.
2. Determine which of the three
bulbs is burned out: stop/taillight/
side marker, back-up or turn
signal.
3. Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
4.
socket. Push the new bulb straight
into the socket until it bottoms.
5. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
6. Turn on the lights to make sure
the new bulb is working.
7. Install the light assembly cover.
Make sure it snaps into place.