Table of Contents
Advertisement
KMR 1250 D
Cleaning the filter
User Instructions
Braking
n Release the drive pedal and the sweeper will brake auto-
matically.
Important note: Safety!
It is possible that the automatic braking function will not be
sufficient to bring the sweeper to a halt. In this case, either
make use of the parking brake as well or gently press the
drive pedal in the opposite direction to travel.
Stopping the sweeper and switching off
n Release the drive pedal. The sweeper brakes automati-
cally and comes to a halt.
n Apply the parking brake
n Set the throttle lever to minimum engine speed (to the
rear).
n Make sure the main roller
raised so that the bristles are not damaged.
n Switching off
– Turn the ignition key counter-clockwise to the 0 positi-
on and then remove it.
After the engine has been switched off, the filter is
automatically cleaned for approx. 10 seconds.
Automatic cleaning
n Stop the sweeper and switch off the engine.
After the engine has been switched off, the filter is auto-
matically cleaned for approx. 10 seconds.
Manual cleaning
While the sweeper is operating, the filter should be cleaned
approx. every 15–30 minutes (depending on amount of
dust).
n Stop the sweeper.
n Set the sweeping mode lever to wet
n Give a short press on the filter cleaner button
filter is cleaned for about 10 seconds. .
n Set the sweeping mode lever back to dry
n Continue with cleaning task as before.
.
and side brush
.
.
English
are
, the
35
Advertisement
Table of Contents
