License Plate Lamp - Buick 2011 LaCrosse Owner's Manual

To replace one of these lamps:
1. Open the trunk. See Trunk on
page 2 12.
2. Remove fasteners and pull back
the trunk trim.
3. Remove the four plastic wing
nuts retaining the taillamp
assembly in place.
4. Pull out the taillamp assembly
and disconnect the wiring
harness.
A. Back-up Lamp
B. Turn Signal Lamp
5. Turn the bulb socket
counterclockwise to remove it.
6. Pull the old bulb straight out of
the bulb socket.
7. Push the new bulb straight into
the bulb socket until it clicks.
8. Turn the bulb socket clockwise
to reinstall.
9. Reconnect the wiring harness.
10. Push the taillamp assembly
back into place on the vehicle.
11. Turn the four wing nuts
clockwise to reinstall them.
12. Place the trunk trim to its
original location.
Vehicle Care

License Plate Lamp

The license plate lamps for this
vehicle are on the trunk lid.
To replace one of these bulbs:
1. Open the trunk. See Trunk on
page 2 12 for more information.
2. Push the end on either of the
lamp assemblies (passenger
side shown) and then move the
lamp assembly down to remove
it from trunk lid.
10-35