Table of Contents
Advertisement
Overview
Overview
Overview
Overview
Before you start using this system, please read the following to ensure proper operation:
Temperature Warning
If the system was stored in a location where the temperature dropped below 32° F (0° C)
within the past 24 hours, leave the autoloader in a warm room with temperatures at least
65° F (19° C) for four hours prior to powering it on for the first time. Failure to do so may
cause irreparable harm and prevent the autoloader from
Disc Static and Sticky Media Issues
The most common problems when using an autoloader are the disc static and sticky media
issues. These static charge problems cause multiple discs to stick together, resulting in
improper operation and more severely, can shock the robotic arm while loading a disc that
causes the system freeze. Even though the autoloader has a sticky media separator function
to prevent the sticky media, but you should still follow these steps to prevent sticky media
from disrupting your operation and protect your system from disc static charge.
This issue is most commonly seen when you buy a 100 pack of blank discs and insert them
into the autoloader without any treatment. If you have experienced this kind of problem,
please do the following to remove the adhesive static between the discs:
Separate the blank discs before you place them into the autoloader's bins and align them
using the Output Bin rod. Separating them will greatly reduce the static between discs. See
pictures below:
Zeus Series / Standalone DVD Printer Autoloader / User Manual
12
Advertisement
Table of Contents
