Diode And Audible Continuity Test; Ac Voltage Measurement - SKYTRONIC 600.005 Instruction Manual

DIODE AND AUDIBLE CONTINUITY TEST

Range
TRANSISTOR TEST
Range
PNP & NPN
OPERATING INSTRUCTION
DC VOLTAGE MEASUREMENT
Connect the red test lead to the "VΩ" jack and the black test
1.
lead to the "COM" jack
Set the range switch to the desired " " range. If the voltage
2.
to be measured is not known beforehand, set the range
switch to the highest range and then turn down range by
range until satisfactory resolution is obtained.
Connect the test lead to the source or load to be measured.
3.
Read the voltage value displayed on the LCD.
4.

AC VOLTAGE MEASUREMENT

1) Connect the red test lead to the "VΩ" jack, and the black test
lead to the "COM" jack.
2) Set the range switch to the desired " " range. If the
voltage to be measured is not known beforehand, set
the range switch to the highest range and then turn down
range by range until satisfactory resolution is obtained.
3) Connect the test lead to the source or load to be measured.
4) Read the voltage value displayed on the LCD.
Description
The approx. forward
voltage drop of the diode
will be displayed on the
LCD.
If the resistance of the
circuit under test is less
than 40Ω, the built-in
buzzer will sound.
hFE
0~1000
Test Condition
The forward DC current
is approx. 1mA, the
reversed DC voltage is
approx. 2.8V.
Open circuit voltage is
approx. 2.8V.
Test Current
1b=10µA
Test Voltage
Vce=2.8V