Reset
Reset switch is used for restarting or resetting the camera as Factory Default (FD). Refer to the
section "6.3. Reset" for more specific information.
USB connector
Insert a USB storage device or Wi‐Fi devices. (Ralink RT73 or RT3070 chipset based wireless
device is available.)
9 pin terminal block for D/I, D/O, audio, and serial communication
Refer to the section "5.1.Connectors" for more specific information.
Power Adaptor Connector (DC 12V)
The camera needs a DC12V for power supply. Refer to the section "Power Adaptor Connector
(DC 12V)" for more specific information.
!
Make sure the polarity is correct. Incorrect connection may cause malfunction
or damage to the IP device.
Caution
Micro SD Card slot
It is a memory card slot for external storage. AVI recording using a SD card will be supported in
the future.
LAN Connector (Ethernet)
This is a RJ45 LAN connector for 10/100 Base‐T Ethernet.
Adaptor for mounting the camera
Mounting points adaptor is provided on the bottom (or the top) of the camera for mounting
the camera on a bracket or tripod.
+ ‐
Status LED Network LED
NM‐IP1100M
7