Crysalli CR-UCM1 Quick Installation Manual

CR-UCM1 & CR-UCM2 Undercounter Chilled Sparkling Water Dispenser
1. Select a counter location for your draft tower and an undercounter or remote
location for your CR-UCM# unit (unit requires a minimum of 6" on all side
and top). Place the CR-UM# unit as close as possible to water filter
connection & 120-volt electrical outlet.
2. Place the condenser coil facing out for best air in to unit and access to the air
filter. Allow for air flow out of cabinet as well (louver paneling if enclosed).
Without adequate air flow the unit will not operate properly.
3. Mount the draft tower and drain pan. Take care to tighten the faucets on to
the tower. Plumb the drain line from pan to the floor sink. Use silicone on
bottom and edges of drain pan for best seal.
4. Mount the Water Filter System in an accessible location. The CR-24FC Filter
system has a ¾" fpt inlet and outlet, so use the adaptors in the install kit to
reduce down to accommodate your line size. Use the 3/8" ID braded hose for
the outlet tubing of the filter to the CR-UCM chiller.
5. If using a Back Flow Preventer and or Water Pressure Regulator supplied in
the install kit, plumb in after the water filter system. Use Water Pressure
Regulator when incoming water pressure is above 65 PSI.
6. Measure and Route the needed length of CR-4L38 insulated trunk line from
the CR-UCM# unit to the location of the draft tower. Leave extra line for
bends.
7. At the CR-UCM#, cut back 8" of insulation from the trunkline to expose the 4
tubes for the connections to the chiller.
8. Connect the four 90 degree John Guest adaptor fitting to the four outlets at
the manifold on the chiller (marked: Soda Water, Water Bath In, Water Bath
Out and Cold Water) if needed to accommodate space. Connect the Blue
striped tube to "Soda Water", the clear tube to "Cold Water" and the red
striped tubes to the "Water bath" outlets.
9. At the tower end of the trunkline, Cut back about 4" of insulation and cut the
red stripped tubes so they are 1" longer then the clear and blue striped ones.
Crysalli/Western Pacific – 1739 Sabre Street Hayward, CA 800-229-4410 www.crysalli.com
Quick Installation Guide Instructions
1
12213