Advertisement
Network Connection - Wired
There are two main ways to connect
your
TV to
your
network
using
cable, depending on
your
network
setup.
They are
illustrated below:
The Modem Port
on the
Wall
Extternal Modem
(ADSL
I
VDSL
I
Cable TV)
Modem
Cable (Not
Supplied)
The LAN Port on the Wall
LAN
Cable (Not
Supplied)
~A
network speed of lower of than 10 Mbps is not supported.
Configuring the Network Connection - Wired
1V
Rear
Panel
LAN
Cable (Not Supplied)
1V Rear Panel
Most home networks use the Dynamic Host Configuration Protocol
(DHCP)
to configure network connections. Home networks
that support DHCP automatically provide the IP
address,
subnet mask, gateway, and DNS values your 1V needs to access the
Internet so you don't have to enter them manually.
To configure your network connection for a network that uses DHCP,
follow these steps:
1.
Connect your 1V to your network as shown in one of the
illustrations above.
2.
Turn on your TV, press the
MENU
button on your remote, and then
select
Network
----+
Network Settings.
The
Network Settings
screen will appear.
3.
Select
Wired,
press
ENTER
G.
and then press
ENTERGJ
again.
4. The Network Connection screen appears, and verifies the network
connection. When the connection has been verified, the
"Internet
is
connected successfully." message appears. Network set up is
completed.
~
If your TV cannot acquire network the connection values
~
The displayed image may differ depending on
the model.
automatically or if you want to set the connection manually, select
IP Settings
on the network test screen. Set
Internet
Protocol Setup to Manual.
You must enter the
IP Address, Subnet Mask, Gateway,
and
DNS Server
manually.
~
For more detailed information, see
"Wired
Network Connection" in the e-Manual.
Advertisement
