Table of Contents
Advertisement
Tomcat i875P S5102
3.12 – Supervisor/User Password Setting
Phoenix – AwardBIOS CMOS Setup Utility
► Standard CMOS Features
► Advanced BIOS Features
► Advanced Chipset Features
► Integrated Peripherals
► Power Management Setup
Enter Password:
► PnP/PCI Configurations
► PC Health Status
Esc: Quit
F10: Save & Exit Setup
You can set either a supervisor or a user password, or both of them. The differences are:
Set Supervisor Password: can enter and change the options of the setup menus.
Set User Password: Can enter but does not have permission to change any options.
When you select this function, the following message will appear at the center of the screen to
assist you in creating a password.
ENTER PASSWORD:
Phoenix – AwardBIOS CMOS Setup Utility
► Standard CMOS Features
► Advanced BIOS Features
► Advanced Chipset Features
► Integrated Peripherals
► Power Management Setup
► PnP/PCI Configurations
► PC Health Status
Esc: Quit
F10: Save & Exit Setup
Type the password, up to eight characters in length, and press <Enter>. The password typed
now will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press <Enter>. You may also press
<Esc> to abort the selection and not enter a password.
► Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
↑ ↓ ← →: Select Item
Change/Set/Disable Password
► Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Enter Password:
Exit Without Saving
↑ ↓ ← →: Select Item
Change/Set/Disable Password
3-22
http://www.tyan.com
Chapter 3: BIOS Setup
Advertisement
Table of Contents
