Programming Transmitters To The Vehicle - Buick 2011 Lucerne Owner's Manual

(Lock): Press to lock all the doors. If enabled
through the Driver Information Center (DIC), the parking
lamps flash once to indicate locking has occurred.
If enabled through the DIC, the horn chirps when
pressed again within five seconds. See DIC Vehicle
Customization on page 4 56 for additional information.
Pressing may arm the content theft deterrent system.
See Content Theft-Deterrent on page 3 15.
(Unlock): Press once to unlock the driver door. If
pressed again within five seconds, all remaining doors
unlock. The interior lamps come on and stay on for
20 seconds or until the ignition is turned on. If enabled
through the DIC, the parking lamps flash twice to
indicate unlocking has occurred. See DIC Vehicle
Customization on page 4 56.
Pressing on the RKE transmitter disarms the content
theft deterrent system. See Content Theft-Deterrent on
page 3 15.
(Remote Trunk Release): Press and hold for
about one second to unlock the trunk. The transmission
must be in P (Park).
(Vehicle Locator/Panic Alarm): Press and release
to locate the vehicle. The turn signal lamps flash and
the horn sounds three times.
Press and hold
activate the panic alarm. The turn signal lamps flash
and the horn sounds repeatedly for 30 seconds. The
alarm turns off when the ignition is moved to ON/RUN
is
or is pressed again. The ignition must be in LOCK/
OFF for the panic alarm to work.
The vehicle comes with two transmitters. Each
transmitter will have a number on it, "1" or "2". These
numbers correspond to the driver of the vehicle. For
is
example, the memory seat position for driver 1 will be
recalled when using the transmitter labeled "1",
if enabled through the DIC. See Memory Seat and
Mirrors on page 2 7 and DIC Vehicle Customization
on page 4 56 for more information.
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement can
be purchased and programmed through your dealer.
When the replacement transmitter is programmed to the
vehicle, all remaining transmitters must also be
programmed. Any lost or stolen transmitters no longer
work once the new transmitter is programmed. Each
vehicle can have up to eight transmitters programmed
to it. See your dealer for programming new transmitters.
for more than two seconds to
3-5