Advertisement
Removing the Baseband board Assembly screws
The two 1.8 x 12mm pan head screws need to be removed using a torx T6
screwdriver. This will allow access to the Baseband and TRX Assembly.
Removal of Baseband board from B-Cover Assembly
A
A –
A –
Pull the retaining clips gently outwards and lift the baseband board
slightly to release the SK500 socket from PL400.
B -
B -
Raise the baseband board from the retaining clip side. This will
make dis-assembly easier.
The next stage is to remove the baseband board away from the assembly. This
should be done in order to dislocate the location tabs from the locating holes. The
baseband board will then be free from the B–Cover assembly.
B
Location tabs
B
Locating Eyes
Advertisement
