Charger Location; Dc Connection Precautions; Follow These Steps When Battery Is Installed In Vehicle - Schumacher SE-1-12S Owner's Manual

4.

CHARGER LOCATiON

4.2 When mounting the charger to the fender well, locate the charger
as far away from the battery as the DC cables permit.
4.3 Never place the charger directly above the battery being charged;
gases from the battery will corrode and damage the charger.
4.4 With the exception of the charger mounting bracket, do not set the
battery on top of the charger.
4.5 Never allow battery acid to drip onto the charger when reading the
electrolyte specific gravity or filling the battery.
4.6 Do not operate the charger in a closed-in area or restrict the
ventilation in any way.
5.

dC CONNECTiON PRECAUTiONS

5.1
Connect and disconnect the DC output ring terminals only after
removing the AC plug from the electric outlet.
5.2 Attach the ring terminals to the battery and chassis, as indicated
in sections 6 and 7.
6. FOLLOW THESE STEPS WHEN BATTERY iS iNSTALLEd
iN VEHiCLE
6.1 Position the AC and DC cables to reduce the risk of damage by
the hood, door and moving or hot engine parts. NOTE: If it is
necessary to close the hood during the charging process, ensure
that the hood does not touch the metal part of the ring terminals
or cut the insulation of the cables.
RiSK OF EXPLOSiON
ANd CONTACT WiTH
BATTERY ACid.
4.1
far away from the battery as
the DC cables permit.
A SPARK NEAR THE
BATTERY MAY CAUSE A
BATTERY EXPLOSiON.
TO REdUCE THE RiSK
OF A SPARK NEAR THE
BATTERY:
• 5 •
Locate the charger as