Table of Contents
Advertisement
Dipswitch #10 is used to set master or slave mode. Master modes have sound active and AUTO mode. Slave modes have DMX and
Slave mode. The units automatically identify DMX or SLAVE mode by data received. Dipswitch #9 is used to set sound active or AUTO
mode in master mode.
DMX ADDRESS CALCULATION
In DMX mode, the DIP switch from # 1 to # 9 should be set to record a DMX address. The address ranges from 1-511. Each dipswitch
represents a binary value. Please refer to table below.
Dipswitch
VALUE
＃1
＃2
＃3
＃4
＃5
Each unit has 7 channels. So each product may be receiving a 7-channel DMX address at least. If you assign an address on 8 channels,
the DMX address is: 8*N +1, N=0, 1, 2, 3....
Example: Address 1 loop =1
Address 2 loop = 9
Address 3 loop = 17
Address 4 loop = 25
LOOP
ADDRESS
1
1
2
9
3
17
4
25
Please refer to the chart on the last page to set the DIP switch according to the DMX address assignment.
4.
OPERATION
a.
STAND ALONE OPERATION : Sound activation and AUTO
This mode allows a single device to react to the sound of music.
1.
Place the device in a suitable and stable position.
2.
Set the dipswitch to select AUTO or Sound active mode.
3.
Turn on the unit. The unit resets then it begins to work.
4.
The unit will react to low frequencies through the internal microphone. Adjust the sound sensitivity with the appropriate knob
located at the rear of the unit. The LED indicates whether the music mode is activated.
Dipswitch
＃6
1
＃7
2
＃8
4
＃9
8
＃10
16
CODE
DIPSWITCH
100000000
#1
100100000
#1+#4
100010000
#1+#5
100110000
#1+#4+#5
VALUE
32
64
128
256
DMX, on "0"
Advertisement
Table of Contents
