Scanning Frequencies; Electrical Characteristics; Interface Signals; Video: 0.7 Vp-P, Input Impedance, 75 Ohm @Dc - Philips 170S8FS/00 Service Manual

HUDSON 8
102
AUO M170EG01 VD
Resolution
Outside dimensions
Pitch ( mm )
Color pixel arrangement
Display surface
Color depth
Backlight
Active area(WxH)
View angle (CR>10)
Contrast ratio
White luminance
Color gamut
Gate IC
Source IC
Response time

2.2 Scanning frequencies

Hor. : 30 – 83 K Hz
Ver.: 56 - 76 Hz
Video dot rate: <140 MHz
Power input: 90-264 V AC, 50/60 ± 2 Hz
Power consumption : : 36 W typical
Functions:
(1)D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
(2) DVI digital Panel Link TMDS inputs
2.3 Ambient temperature:

3. Electrical characteristics

3.1 Interface signals

1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3). Audio: NOTE
4). USB PLUG 2.0: NOTE
: 1280x1024 (SXGA)
:
: 0.264 mm x 0.264 mm
: RGB vertical stripes
: Anti-glare type, Hardness 3H
: 16.7 M color (RGB 6 bits + FRC data)
: CCFL
: 337.9*270.3
: 160/160 (typ)
: 800:1 (typ)
: 300 nits (typ)
: 72% (typ)
:
:
: 5ms
0 °C - 40 °C
TTL level , input impedance 2.2k ohm terminate
(Positive/Negative)