Panasonic WV-CF374E Installation Manual page 20

3 Zoom and focus adjustment
Perform the zoom and focus adjustments at the same time as pan and tilt adjustments (Step 2).
Note:
• If the camera is used in near-horizontal position, the shadow of the dome cover may appear in
the image.
Adjustment on
<
Focus knob
NEAR
WIDE
Loosen the zoom knob and focus knob. Select photographic subject and choose proper view
1
angle through zooming. Adjust the zoom and focus rings to make the image clear (approximate
adjustment).
Note:
• The focus may not be adjusted smoothly when the zoom ring is extremely close to the end of
W direction (T direction). At this time, slightly adjust the zoom ring towards the T direction (W
direction), and then adjust the focus.
Tighten the zoom knob.
2
Press the [SET] button.
3
→ The "FOCUS ADJUSTMENT" screen will appear.
The focus assist function will be activated to perform the optimum adjustment.
When the focus ring is positioned near the best focus position, the position will automatically be
4
memorized as the "PEAK HOLD" position (the higher the value is, the closer it is to the focus point).
When the focus ring is moved, the current focus position will be indicated on "INDICATOR".
5
Adjust the focus position so that the indicator value goes close to the "PEAK HOLD" position.
When the indicator value goes to the best focus position, "BEST FOCUS" will be displayed in
6
reverse at the lower right corner of the screen.
Press the [SET] button again to close the "FOCUS ADJUSTMENT" menu. (No operation for 3
7
minutes also closes the menu.)
Important:
• If the view angle changes during adjustment, press the [SET] button to close the "FOCUS
ADJUSTMENT" screen (once the view angle changes, the "PEAKHOLD" and "INDICATOR"
values will also change), and repeat from step 4 after the view angle is fixed.
20
WV-CF344E, WV-CF374E>
Lens
FAR
TELE
Zoom knob
FOCUS ADJUSTMENT
LOW
................... I
INDICATOR 1135 BEST
PEAK HOLD 1135 FOCUS
HIGH